So far, all we've done in the video series is configure Access Lists -- we haven't actually applied any of them to an Interface. That will be the focus of this video.

We'll talk through the commands "ip access-group" and "ipv6 traffic-filter" and provide some configuration examples. We'll then provide the full scope of what was discussed in part 1: that you can apply one ACL per interface, per direction, per protocol.

Timestamps:

0:00 - Start
0:12 - Review of Part 1
0:51 - Applying ACLs to Interfaces
1:37 - Applying IPv6 ACLs to Interfaces
2:21 - Maximum number of ACLs applied to an Interface
3:12 - Outro and Teaser for next video

Part 1 - What are Access Lists? https://www.youtube.com/watch?v=0gGhuYOh-54

Part 2 - Numbered ACL Syntax https://www.youtube.com/watch?v=wuiWX1yTd98

Part 3 - Numbered ACL Configuration Demonstration https://www.youtube.com/watch?v=3iu7NSqBTDg

Part 4 - Named ACL Syntax https://www.youtube.com/watch?v=7JdsrLW5Tvw

Part 5 - Named ACL Configuration Demonstration https://www.youtube.com/watch?v=GG8E5FIx9s4

Part 6 - IPv6 ACLs - Syntax and Demonstration https://www.youtube.com/watch?v=DR5ph1jY0Lk

Part 7 - Applying ACLs to Interfaces https://www.youtube.com/watch?v=rqX8JaN02cg

Part 8 - Where should you apply ACLs (closer to source or destination?) https://www.youtube.com/watch?v=FV8pQfbMODs

Entire Series: https://www.practicalnetworking.net/series/access-lists/acls/